User Manual

139

Chapter 14. MIDI/Time Code

This chapter explains how MIDI messages and time code (LTC) can be used to control events on the PM1D.

Using MIDI program changes to control events

On the PM1D system, you can assign speciﬁc events (scene recall/effect recall) to MIDI program numbers, so that the

speciﬁed event will be executed when the corresponding MIDI program change number is received. It is also possible to

cause program change messages to be transmitted to an external device when a speciﬁc event is executed on the console.

[Procedure]

1. Connect the MIDI OUT connector of the external

device to the MIDI IN connector of the console (or

engine). Connect, the MIDI OUT connector of the

console (or engine) to the MIDI IN connector of the

external device.

• MIDI connections between the PM1D system and an external device

2. In the LCD FUNCTION ACCESS block, press the

[MIDI/GPI/TC] switch several times to access the

following MIDI PROGRAM screen.

•

MIDI PROGRAM screen (MIDI/GPI/TC function)

In the MIDI PROGRAM screen you can select the

port at which MIDI messages will be transmitted and

received, specify how they will be transmitted and

received, and assign an event to each program num-

ber.

MIDI OUT MIDI IN MIDI OUT MIDI IN

Console (CS1D)

External device

(MIDI sequencer, etc.)

LCD FUNCTION ACCESS

block

[MIDI/GPI/TC] switch