User Manual
CS1D Reference Manual (Hardware)
8
B
INPUT [ø] (Phase) LED
If settings have been made to invert the phase of the
input signal for this input channel, this LED will
light.
The phase setting can be changed in the SELECTED
INPUT CHANNEL block of the console, or in the
display (IN HA/INSERT function).
C
INPUT [A]/[B] LED
For an input channel to which an AD card with swit-
chable input jacks A/B has been patched, the corre-
sponding LED will light to indicate the currently
selected input jack (A/B).
For an input channel to which another type of card is
patched, these LEDs will be dark. The A/B input jack
selection can be performed in the SELECTED INPUT
CHANNEL block of the console, or in the display (IN
HA/INSERT function or IN CH VIEW function).
D
INPUT [GAIN] encoder and LED
If an AD card with head amp is patched to this input
channel, this encoder will adjust the input sensitivity
of the head amp.
The adjustable range is +10 dB — –68 dB. The
approximate current value is shown by the LEDs
around the perimeter of the encoder.
The PAD will be internally switched on or off when
the gain of the LMY4-MLF card (including the AI8-
ML8F unit) internal head amp is adjusted between
–8 dB and –7 dB. Keep in mind that noise may be
generated if there is a difference between the Hot
and Cold output impedance of the external device
connected to the card when using phantom power.
E
INPUT [CLIP] LED
This LED will light when the input signal of that
input channel has clipped.
If this LED lights for an input channel to which an
AD card with head amp has been patched, use the
INPUT [GAIN] encoder (
D
) to lower the input sen-
sitivity. If this LED lights for an input channel to
which an AD card without a head amp or a digital I/
O card has been patched, lower the output level of
the sound source that is connected to the card.
F
COMP [+]/[THR]/[–] LEDs
The LEDs indicate the operating status of the inter-
nal compressor. If the compressor is turned off, all
LEDs will be dark.
If the compressor is turned on, one of the LEDs will
light to indicate the currently selected type and status
of the compressor.
When the compressor type is COMP
When the compressor type is EXPANDER
When the compressor type is COMPANDER
+
THR
-
COMP
+
THR
-
CLIP
6
12
18
30
60
GATE
ON
SEL
H
K
F
G
I
J
Time
Threshold level
Level
Output signal
Key-in signal
[–] [–][THR] [THR][+]
ATTACK
RELEASE
COMP
Time
Threshold level
Level
Output signal
Key-in signal
[–] [–]
[THR]
[THR][+]
RELEASE
EXPANDER
AT TAC K
[–] [–]
[THR] [THR]
[+]
RELEASE
WIDTH
AT TAC K
AT TAC K
RELEASE
Time
Threshold level
Level
Output signal
Key-in signal
COMPANDER