User Manual

ManualsBrandsYamaha ManualsBrass & WoodwindsPM1

251

252

253

254

255

256

257

258

259

260

CS1D Reference Manual (Hardware)

MIX channel section

In this section you can switch the on/off status and set the output level of each MIX channel 1–48.

1 MIX [NAME] indicator

This displays the short name of the MIX channel.

The short name can be input in the display (OUT

PATCH function NAME screen, etc.).

2 MIX [TO ST] switch and LED

This is an on/off switch for the signal that is sent

form the MIX channel to the STEREO bus. (The

LED will light when this is on.)

3 MIX [TO MTRX] switch and LED

This is an on/off switch for the signal that is sent

from the MIX channel to the MATRIX bus. (The

LED will light when this is on.)

When this switch is off, no signal will be sent from

that MIX channel to any MATRIX bus.

4 MIX [ON] switch and LED

This is the on/off switch for the MIX channel. (The

LED will light when this is on.)

When this switch is off, a signal will not be sent to

the channel of the output unit that is patched to the

corresponding MIX channel.

Hint

Even if this switch is off, a signal can be sent from the

MIX channel to a MATRIX bus or the STEREO bus.

To do this, make settings in the display (MATRIX/ST

function MATRIX/ST ROUTING screen) so that the

signal is sent to the MATRIX buses or the STEREO

bus from a point earlier than the MIX [ON] switch.

5 MIX [RCL SAFE] LED

This LED will light for MIX channels that are set to

Recall Safe (a state in which the channel will be unaf-

fected by scene recall operations).

The parameters of a MIX channel for which this LED

is lit will not change even if a scene memory is

recalled.

Recall Safe settings can be made in the SELECTED

OUTPUT CHANNEL bolck or display (SCENE

function RECALL SAFE screen).

6 MIX [MUTE SAFE] LED

This LED will light for MIX channels that are set to

Mute Safe (a state in which the channel will be unaf-

fected by mute group operations).

A MIX channel for which this LED is lit will be unaf-

fected even if a mute group to which it belongs is

muted.

Mute Safe settings can be made in the SELECTED

OUTPUT CHANNEL block or display (OUT DCA/

MUTE function MUTE GROUP ASSIGN screen).

7 MIX [DCA] switch and LEDs

This switch assigns the MIX channel to DCA groups

9–12.

When the MIX channel is assigned to a DCA group,

the corresponding LED will light.

Hint

You can assign a single MIX channel to multiple

DCA groups, and assign multiple MIX channels to a

single DCA group.

PAIR

ON ON