User Manual

MASTER block

ENGINE section

If two DSP1D (or DSP1D-EX) DSP units are connected to a single CS1D, this section selects the DSP unit that will be

controlled.

1 ENGINE [A]/[B] switches and LEDs

These switches select which of two DSP1D (or

DSP1D-EX) DSP units will be controlled by the

CS1D.

The LED of the currently selected switch will light.

PM1D system version 1.0 does not support addi-

tional DSP units except when using Mirror mode.

GLOBAL LAYER section

On 96 channel models with a DSP card installed in the DSP unit, this section selects the input channels that will be con-

trolled. {On 48 channel models this section has no function.}

1 [1–48]/[49–96] switches and LEDs

These switches select either channels 1–48 or 49–96

as the input channels to be controlled by INPUT

blocks 1–4 of a 96 channel model.

In the same way you can switch between 1–4 or 5–8

as the ST IN channels that will be controlled in the

ST IN block.

The LED of the currently selected switch will light.

GLOBAL LAYER