User Manual

Rear panel block
105
DIGITAL I/O section
1 DIGITAL I/O CONSOLE connectors (1/2)
These are 68-pin D-sub connectors that exchange
multi-channel digital audio signals with a second
CS1D console when two CS1D consoles are used in a
single PM1D system (Dual Console mode). Connect
the first console’s DIGITAL I/O CONSOLE connec-
tor to the second console’s DIGITAL I/O ENGINE A
connector.
2 DIGITAL I/O ENGINE B jacks (1/2)
These are 68 pin D-sub connectors that exchange
multi-channel digital audio signals with the two
DSP1D-EX {DSP1D} DSP units (engines A/B) con-
nected in a mirror configuration to a single CS1D.
3 DIGITAL I/O ENGINE A jacks (1/2)
These are 68 pin D-sub connector that exchange
multi-channel digital audio signals with a connected
DSP1D-EX {DSP1D}.
When using two CS1D consoles in a single PM1D
system (Dual Console mode), connect the first con-
sole’s DIGITAL I/O CONSOLE connector to the sec-
ond console’s DIGITAL I/O ENGINE A connector.
Hint
The connectors of the DIGITAL I/O section will
operate correctly if either connector 1 or 2 is con-
nected. However by connecting both 1 and 2, you
can use one as a standby in the event of unexpected
problems. For normal operation, only one of the
cables will be used. If a communication error occurs
and transmission becomes impossible, the PM1D
system will automatically switch to the correctly-
functioning cable and will attempt to reestablish
communication.
2
CONSOLE
1 2121
ENGINE B
DIGITAL I/O
ENGINE A
1 2 3