User Manual

EFFECTGEQSCENEMIDI/GPI/TCUTILITY
SYS/W.CLOCK
METERMON/CUE
METER functions
59
3 METERING POINT
These buttons select the metering point at which the
input levels will be measured, from the following
choices.
• PRE ATT .............Before the attenuator
• PRE GATE ..........Immediately before the internal
gate
• PRE FADER........Immediately before the fader
• POST FADER.....Immediately after the fader
• POST ON............Immediately after the [ON]
switch
• These five buttons are independent of the METER
[PRE] switch in the METER section (MASTER
block) of the CS1D top panel.
• The peak hold function will be momentarily cleared
when you change the metering point.
4 PEAK HOLD
If this button is on, the peak level of each meter will
be held.
When this button is turned off, the peak level display
that had been held until then will be cleared.
Peak hold will also be cleared when you change the
METERING POINT (3) setting.
The PEAK HOLD button in the input meter screen
is independent of the METER [PEAK HOLD]
switch in the METER section (MASTER block) of
the CS1D top panel.
4
3