User Manual

EFFECTGEQSCENEMIDI/GPI/TCUTILITY
SYS/W.CLOCK
METERMON/CUE
MON/CUE (monitor/cue) functions
65
5 SINE WAVE FREQ (sine wave frequency)
This knob sets the frequency of the sine wave that is
output by the oscillator.
The range is 20 Hz–20 kHz, and the current value is
shown in the number box below.
6 10 kHz/1 kHz/100 Hz
These buttons select preset sine wave frequencies.
7 PINK NOISE/BURST NOISE
These buttons output noise instead of a sine wave.
• When the PINK NOISE button is on
Pink noise at a continuous level will be output to the
specified bus or output jack.
• When the BURST NOISE button is on
Repeated bursts of pink noise will be output to the
specified bus or output jack.
The duration of the noise (WIDTH) and the time
interval between the beginning of each noise burst
(INTERVAL) can be set using the respective knobs
(8).
• When the PINK NOISE/BURST NOISE buttons
are off
A sine wave will be sent to the specified bus or output
jack.
8 WIDTH & INTERVAL
When burst noise is selected, these knobs adjust the
time duration of the noise itself, and the spacing at
which each burst will begin.
The range is 0.1–10 seconds for WIDTH, and 1–30
seconds for INTERVAL. (The current value is shown
in the numerical box immediately below.)
9 LPF/HPF knobs
These knobs set the cutoff frequency of the LPF/HPF
through which the pink noise/burst noise will pass.
The range is 20 Hz – 20 kHz for both knobs, and the
current value is shown in the numerical box immedi-
ately below.
0 LPF/HPF ON, OFF
These are on/off switches for the LPF/HPF.
A ASSIGN
Select the bus or output jack to which the sine wave
or noise will be output, from the following choices.
(You may select more than one.)
• STEREO ............. STEREO bus
• MIX 1–48 ........... MIX buses 1–48
• MATRIX 1–24.... MATRIX buses 1–24
6
80
9
7
5
Level
Time
Pink noise output
The PINK NOISE button is on
INTERVAL
WIDTH
Level
Time
Pink noise output
The BURST NOISE button is on
A