User Manual

OUT DCA/MUTE (output DCA/mute) function
101
OUT PATCHOUT INSERTOUT EQOUT COMPOUT DELAY
OUT DCA/MUTE
MATRIX/STOUT CH VIEW
OUT DCA/MUTE (output DCA/mute) function
Set DCA and mute group settings for the output channels
DCA ASSIGN
[Function]
Assign output channels to DCA faders 9–12 and operate the DCA faders 9–12.
■ Console
In the LCD FUNCTION ACCESS
block, press the OUTPUT [DCA/
MUTE] (press repeatedly until the
screen shown at the right appears)
■ Display
MENU button → OUTPUT DCA/
MUTE button → DCA ASSIGN tab
[Screen functions]
1 These are the DCA group numbers. The number
corresponding to the grid where the cursor is cur-
rently located will be highlighted.
Only DCA faders 9–12 can be assigned to output
channels.
2 These are the eight-character names displayed in the
DCA fader section. You can also click here and mod-
ify the names of the DCA faders.
3 Grid
In this grid you can assign output channels (horizon-
tal lines) to DCA faders (vertical columns. Currently-
patched grids will be indicated by a ● symbol. Move
the cursor to the desired grid, and press the [ENTER]
switch (or click) to set/cancel an assignment.
Hint
You can also use multiple DCA control by assigning a
single output channel to more than one DCA fader.
• DCA faders 9–12 can be used for either input chan-
nels or output channels. However, it is not possible
to assign both input and output channels to the same
DCA fader. For this reason, if an input channel is
already assigned to a DCA fader 9–12, it will not be
possible to assign an output channel to the same
DCA fader.
1
2
3