User Manual

ManualsBrandsYamaha ManualsBrass & WoodwindsPM1

441

442

443

444

445

446

447

448

449

450

MATRIX/ST (matrix/stereo) function

107

OUT PATCHOUT INSERTOUT EQOUT COMPOUT DELAY

OUT DCA/MUTE

MATRIX/STOUT CH VIEW

3 MIX TO MATRIX ON/OFF (MIX → MATRIX on/

off)

This button is an on/off switch for the signal that is

sent from the MIX channel/STEREO A/B to the

MATRIX bus. This is linked with the [TO MATRIX]

switch on the MIX OUTPUT block of the console.

When this button is off, no signal will be sent from

that channel to the MATRIX bus.

4 PRE FADER/POST FADER/POST ON

These buttons select the location at which the signal

will be sent from the MIX channel/STEREO A/B

channel to the MATRIX bus.

• When the PRE FADER button is on

The signal from immediately before the fader will be

sent.

• When the POST FADER button is on

The signal from immediately after the fader will be

sent.

• When the POST ON button is on

The signal from immediately after the MIX [ON]

switch/STEREO [ON] switch on the CS1D will be

sent.

This parameter affects all signals that are sent from

the corresponding channel to the MATRIX buses.

5 ON/OFF (MIX → STEREO on/off)

This button is an on/off switch for the signal that is

sent from the MIX channel to the STEREO bus. This

is linked with the [TO ST] switch on the MIX OUT-

PUT block of the console.

When this button is off, no signal will be sent from

that channel to the STEREO bus.

6 PRE/POST (pre-fader/post on)

This button selects the location at which the signal is

sent from the MIX channel to the STEREO bus.

If this is turned on (POST), the signal after the [ON]

switch will be sent. If this is turned off (PRE), the

pre-fader signal will be sent.

7 PAN (MIX → STEREO pan)

This knob sets the panning of the signal that is sent

from the MIX channel to the STEREO bus.

If the [TO ST PAN] switch is turned on in the

SELECTED OUTPUT CHANNEL block of the CS1D

console, this knob will be linked with the [PAN]

encoder of the SELECTED OUTPUT CHANNEL

block.

Hint

If the send source is the STEREO A/B channel,

parameters 5–7 will not be displayed.

8 Pairing/send source channel

This displays the number and short name of the send

source MIX channel/STEREO A/B channel and its

pairing status.

You can also click the heart symbol to set/defeat pair-

ing.