User Manual

38
Checking the operation of an output unit
This section explains the procedure for checking the operation of an output unit connected to the DSP1D-EX {DSP1D}
engine. The general procedure is as follows.
Connect an input source to an input unit
mm
mm
Connect your monitor system to an output unit
mm
mm
Tu rn on the power in the order of input unit → DSP1D-EX {DSP1D} engine → CS1D console → monitor system
mm
mm
Patch the input unit to an input channel
mm
mm
Patch the output unit to the STEREO A channel
mm
mm
Send the input channel signal to the STEREO bus
mm
mm
Check whether the signal is output from the STEREO OUT A jacks
Preparations for checking
Before you begin checking the operation of an output unit, make sure that the following actions have been completed.
• Connect the various components that are part of
the PM1D system (→p.6–13)
• Use the indicators/LEDs of the input/output units
and the engine to verify that the components are
correctly connected to each other (→p.14–21)
• Set the operation mode and the word clock master
as appropriate for the configuration of the PM1D
system that you are using (→p.22–29).