User Manual

Input functions
150
IN DCA/MUTE functions
Set DCA, and mute group
DCA ASSIGN
[Functions]
Assign input channels to DCA groups 1–12 so that they can be controlled by DCA faders 1–12.
■ Console
In the LCD FUNCTION ACCESS
block, press the INPUT [DCA/
MUTE] switch (Press repeatedly
until the screen shown at the right
appears.)
■ Display
MENU button → INPUT DCA/
MUTE button → DCA ASSIGN tab
[Screen functions]
1 These are the DCA group numbers. The number
corresponding to the grid where the cursor is cur-
rently located will be highlighted.
2 These are the eight-character names displayed in the
DCA fader section. You can also click here and mod-
ify the names of the DCA faders.
3 Grid
This is the grid where input channels (horizontal
rows) can be assigned to DCA groups (vertical col-
umns). Move the cursor to the desired grid location,
and press the [ENTER] switch (or click) to set/cancel
the assignment. To access channels that are not cur-
rently displayed, use the horizontal scroll bar.
Hint
It is possible to assign a single input channel to two
or more DCA groups for multiple DCA control. For
details refer to the section on basic operation.
• DCA groups 9–12 can be used for either input chan-
nels or output channels. However, it is not possible
to use the same DCA fader for both inputs and out-
puts. For this reason, input channels cannot be
assigned to a DCA group 9–12 to which an output
channel has already been assigned.
1
2
3