User Manual

Checking the operation of an output unit
41
Patch the input unit to an input channel
Patch the input jack to which you connected the input source to input channels 1/2. For details of the procedure, refer to
page 33.
[Procedure]
1. Turn on the power in the order of the PM1D system
→ monitor system.
2. In the LCD FUNCTION ACCESS block, press the
INPUT [PATCH] switch several times to access the
following screen.
3. Patch the input source to input channels 1/49 and
2/50.
The following illustration shows an example of when
jacks 1/2 of an AD card (LMY4-AD) installed in slot
1 of the AI8 are patched to input channels 1/2.
LCD FUNCTION ACCESS
block
INPUT [PATCH] switch