User Manual

Checking the operation of an output unit
43
2. Use the up/down scroll bars to make “ST A[L]” and
“ST A[R]” appear in the vertical column (patch
source) area.
Use the up/down scroll bar to see output channels
that are not currently visible. “ST A[L]” and “ST
A[R]” correspond to STEREO A channels L and R
respectively.
3. Use the left/right scroll bar to make the output unit
to which your monitor system is connected appear
in the horizontal row (patch destination) of the dis-
play.
4. Patch “ST A[L]” and “ST A[R]” to the jacks to which
your monitor system is connected.
The following illustration shows the example of
when jacks 1/2 of a DA card (LMY4-DA) installed in
slot 1 of the AO8 are patched to the L/R channels of
STEREO A.
In this grid, output jacks (horizontal rows) can be patched to output channels (vertical columns).
A ● symbol will be displayed for currently-patched grids. This is the OUTPUT PATCH screen in
which the output signals of the output channels can be patched to output units or to the inputs of
the internal effects.
Patch desti-
nation out-
put jacks.
From the
top, this
area shows
the type and
ID of the
output unit,
the number
of the slot in
which the
output card
is installed,
and the
channel
(jack) num-
ber within
the card.
Patch source
output
channels.