User Manual
Table Of Contents
- Additions/changes in V1.5
- Changes to the constantly-displayed screen
- DUAL CONSOLE mode added
- Cascade connections
- Using GPI (General Purpose Interface)
- Fader Start function
- Tap Tempo function
- Added functions in the USER DEFINE screen
- Input channel panel assignments
- Horizontal pair and vertical pair
- Mix minus
- Job select
- Auto Store function
- Global Paste function
- Parameter control via CONTROL CHANGE and NRPN
- Manual Fading function
- Unit name
- Matrix send shortcuts
- DCA mute indicator
- Oscillator improvements
- Improvements in the INPUT PATCH / OUTPUT PATCH screens
- USB PC (computer) connection
- Automatic scrolling in the CH to MIX screen and MATRIX/ST ROUTING screen
- ON/OFF button for COMM IN
- Added functions in the PREFERENCE screen
- Supplementary explanation for existing functions
- Scene Memory/Effect Library to Program Change Table
- MIDI control change NRPN (Non Registered Parameter Number) assignment table
- MIDI control change parameter assignment table
- MIDI Data Format
PM1D System Software V1.5 Supplementary Manual
28
1 ENGINE SELECT
If the master and slave systems are being used in Mir-
ror mode, this selects whether switching between
engines A/B will be linked.
2 SCENE RECALL
Selects whether scene recall operations will be linked
between the master and slave systems.
If they are linked, the identically-numbered scene on
the other system will be recalled.
3 CUE STACK/SOLO
Selects whether cue operations and solo operations
will be linked between master/slave consoles 1 and
between master/slave consoles 2.
4 TALKBACK DIMMER ON/OFF
Selects whether dimmer operation due to talkback
will be linked between master/slave consoles 1 and
between master/slave consoles 2.
It is convenient to link the operation if the consoles
are near each other and you want dimming to occur
for both monitors when talkback is turned on.
5 DCA LEVEL/MUTE
Selects whether the DCA group level and mute on/
off state will be linked between master and slave sys-
tems. The DCA group(s) selected by these buttons
will be linked.
If CUE STACK/SOLO is linked, and you cue a DCA
that is selected for DCA LEVEL/MUTE, the same
DCA will be cued on both systems. However, if an
input channel and output channel are assigned to the
same DCA number, they will not be linked.
6 MUTE MASTER
Selects whether the mute group on/off state will be
linked between master and slave systems. The mute
group(s) selected by these buttons will be linked.
7 CASCADE BUS ON/OFF
These buttons select the buses/signals that will be
cascaded between the master and slave systems.
8 TALKBACK TO COMM IN CASCADE SETUP
(Talkback → COMM IN cascade settings)
These buttons select whether the talkback signal of
the master system will be supplied as a COMM IN
signal of the slave system. Settings for console 1 and 2
can be made independently for both master and
slave.
5 6
1
2
3
4
7
8