User Manual

19 Other functions
140 PM5D/PM5D-RH Owner’s Manual Operating section
2
Use the channel selection boxes for the
desired layer (A–F) to select the channel
assigned to each fader 1–8.
To select a channel, click the / buttons located at
the left and right of each box. You can choose from the
following channels.
Hint
• If an input channel or a DCA fader 1–8 is selected, the chan-
nel name is displayed immediately below the channel
selection box.
• Input channels and output channels can coexist in the same
layer.
3
Assign channels to other layers in the same
way.
Hint
Fader Assign settings are not saved in the scene. If desired,
you can save these settings on a memory card as DCA
FADER MODE data.
1
In the FADER MODE section, use the FADER
MODE [A]–[F] keys to select the layer you want
to use.
The key LED will light, and the corresponding layer
will become active. If input channels are assigned to the
DCA faders, the channel names will appear in the
name indicators of the DCA strip.
Hint
You can also switch layers from within the FADER ASSIGN
screen. This screen also shows the values of the DCA faders
and their approximate positions.
2
Operate the faders of the DCA strip.
The level of the corresponding channels will change. If
a channel assigned to a DCA fader is paired (or if one
side of a stereo channel is assigned), the level of the
other paired channel (or the other side of the stereo
channel) will follow.
Note
When a FADER MODE [A]–[F] key is on, and channels other
than DCA channels are assigned to the DCA faders, the
[MUTE] keys of the DCA channel strip are inactive. However,
the [CUE] keys can be used to cue-monitor the corresponding
channel.
Item Selected channel
CH 1–CH48 Input channel 1–48
STIN1L/STIN1R–STIN4L/
STIN4R
ST IN channel 1–4 L or R
FXRTN1L/FXRTN1R–
FXRTN4L/FXRTN4R
FX RTN channel 1–4 L or R
MIX 1–MIX24 MIX channel 1–24
MTRX1–MTRX8 MATRIX channel 1–8
DCA1–8 DCA fader 1–8
Channel selec-
tion box
Controlling the channels assigned to
DCA faders