User Manual

OUTPUT VIEW function
250 PM5D/PM5D-RH Owner’s Manual Reference section
C PASTE
When you click this button, the specified parameters
will be copied from buffer memory to the specified
paste-destination channel.
If an input channel is copied to buffer memory, or if no
paste-destination has been specified, this is grayed-out
and the Paste operation is unavailable.
D PARAMETER SELECT
Here you can select the parameter(s) that will be
pasted. You can select the following parameters.
If the TO MTRX button is on, you can use the
MATRIX buttons (1–8) to select the applicable
MATRIX buses.
E CH SELECT (Channel selection)
Here you can select the paste-destination channel(s).
You can only select channels of the same type as the
copy-source.
Hint
If the copy-source MIX/MATRIX channel is paired, the odd-
numbered channel is copied to the odd-numbered channel(s),
and the even-numbered channel is copied to the even-num-
bered channel(s).
F SET ALL
Specifies the paste-destination as all channels of the
same type as the copy-source.
G CLEAR ALL
De-selects all channels.
ALL All parameters
EQ EQ function settings
COMP COMP function settings
DELAY DELAY function settings
FADER Fader level
ON CH [ON] key on/off status
BAL Balance settings
INSERT Insert on/off status and insert point
TO MTRX Send level to the desired MATRIX bus(es)
DCA Associated DCA group
MUTE Associated mute group
LCR LCR screen settings
WITHOUT
MIX SEND/
WITH MIX
SEND
Selects whether the send level sent from
input channels to the selected MIX bus will
be included (WITH...) or will not be included
(WITHOUT...) in the pasted data.
5
4
3
6
7