User Manual

PM5D/PM5D-RH Owner’s Manual Reference section 277
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
E PRE EQ/PRE FADER
These buttons let you specify in greater detail the loca-
tion from which the pre-fader signal will be sent from
an input channel to the MIX buses. You can choose
one of the following two send locations.
Hint
This setting applies to the signal sent from the corresponding
input channel to all MIX buses.
F FOLLOW PAN
These buttons specify how the TO ST PAN knob (8)
will affect the signal sent from the input channel to
MIX buses.
• VARI
If this button is on, the PAN knob displayed in the CH
to MIX area (
4) will be linked with the TO ST PAN
knob (
8) if VARI-type MIX buses are paired.
• FIXED
If this button is on, the signal from after the TO ST
PAN (
8) knob will be sent to FIXED-type MIX buses.
G TO ST (To stereo)
This button specifies whether the input channel / ST
IN channel will send its signal to the STEREO bus. This
is linked with the [TO STEREO] switch in the
SELECTED CHANNEL section.
H TO ST PAN (To stereo pan)
Here you can adjust the panning of the signal sent from
the input channel / ST IN channel to the STEREO bus.
(The current value is shown in the boxes immediately
below.) This is linked with the encoder if PAN is
selected as the encoder mode, and with the [PAN]
encoder of the SELECTED CHANNEL section.
I PAN MODE
Here you can select one of the following ways in which
pan settings will be linked between adjacent odd-num-
bered/even-numbered input channels (or the left/right
channels of a ST IN channel).
• INDIVIDUAL
The two pan settings will be independent.
• GANG PAN
The two pan settings will be linked in the same direc-
tion. If the two pan values are different when you turn
on this button, pan will be linked while preserving the
existing difference in values.
• INV. GANG (Inverted gang)
The two pan settings will operate in opposite
directions.
• BALANCE
The two PAN knobs will function as BALANCE knobs
that adjust the balance of the signal sent from the odd-
numbered/even-numbered channels (or the L/R chan-
nels of the ST IN channel) to the STEREO bus L/R. If
you choose this setting, the two knobs will be reset to
the center position, and will be linked in the same
direction. Also, the knob markings will change from
red to white.
Note
• Pan mode is always valid, even if the send-source input
channels are not paired.
• You will be unable to operate the TO ST PAN knobs if you
select GANG PAN mode when the two pan knobs are set to
far left and right, or if you select INV.GANG when both pan
knobs are turned all the way in the same direction.
J MIX MINUS
This function sends the same mix as the STEREO bus
— but with a specific input channel removed — to the
desired MIX bus. If you need to send a monitor mix to
a performer or announcer, this is a quick way to give
them the same mix as the STEREO bus but without
their own voice.
Access the desired source input channel in the screen,
and click the MIX MINUS button for that channel; a
window will appear, allowing you to select the MIX bus
for which to make Mix Minus settings.
Hint
As a shortcut to access the above window, you can simulta-
neously press the [SEL] key of the INPUT/ST IN channel strip
and the [SEL] key of the MIX section. However, be aware that
holding down either one of these keys by itself will access a
different shortcut.
In the above window, select the send-destination MIX
bus and click the OK button; the following parameters
will change in the CH to MIX screen.
• In the CH to MIX area of the send-destination MIX
bus, all ON/OFF buttons will turn on.
• In the CH to MIX area of the send-destination MIX
bus, all PRE/POST buttons will be set to POST.
• The send level of signals sent from the source input
channel to the destination MIX bus will be lowered
to –∞ dB.
• The send level of signals sent from all input chan-
nels other than the above to the destination MIX
bus will be set to nominal level (0.0 dB).
PRE FADER Immediately before the fader
PRE EQ Immediately before the EQ
59
J7 K
86