User Manual

PAN/ROUTING function
278 PM5D/PM5D-RH Owner’s Manual Reference section
• The POST ON/POST TO ST button will be set to
POST TO ST for the destination MIX bus.
Note
• Mix Minus does not switch a “mode”; rather, it is a quick way
to make certain settings. This means that even after execut-
ing Mix Minus, you can freely edit the parameters of the CH
to MIX screen.
• When you execute the Mix Minus operation, only the input
channel you selected as the source will be removed from the
mix. If you want to remove more than one input channel
from the signal sent to a specific MIX bus, execute the Mix
Minus operation and then manually change the settings of
other channels.
• If the input channel is paired (or if a ST IN channel is
selected), the send level of the signal sent from both chan-
nels to the target MIX bus will be set to –∞.
• The Mix Minus operation is valid even if the destination MIX
bus is paired. In this case, the PAN setting of the input chan-
nel will be reflected by the PAN settings of the paired MIX
buses.
K Input channel
This is the source input channel (or channels). Paired
input channels (or a ST IN channel) are indicated by a
heart symbol displayed between them. For an input
channel, you can click this symbol to enable/disable
pairing.
You can move the cursor to a parameter in the CH to
COPY area, and then hold down the [SHIFT] key and
click (or press the [SHIFT] key + [ENTER] key) to
copy the value of that parameter to another channel (in
the horizontal direction) or to another MIX bus (in the
vertical direction), or to switch all parameters on/off.
You can use this method to set the following
parameters.
• Mix send on/off
Move the cursor to the SEND ON/OFF button of the
CH to COPY area; then hold down the [SHIFT] key
and click (or press the [SHIFT] key + [ENTER] key) to
access the following window.
To set multiple parameters at once, use the [DATA]
encoder to select one of the following items, and click
the OK button.
ALL OFF [ALL MIX ]
ALL ON [ALL MIX ]
Switch the signals sent from the selected input chan-
nel to all MIX buses on or off together.
ALL OFF [ALL CH ]
ALL ON [ALL CH ]
Switch the signals sent from all input channels to the
selected MIX bus on or off together.
ALL OFF [ALL CH x ALL MIX]
ALL ON [ALL CH x ALL MIX]
Switch the signals sent from all input channels to all
MIX buses on or off together.
• Mix send position
Move the cursor to a PRE/POST button in the CH to
COPY area; then hold down the [SHIFT] key and click
(or press the [SHIFT] key + [ENTER] key) to access
the following window.
To set multiple parameters at once, use the [DATA]
encoder to select one of the following items, and click
the OK button.
ALL POST [ALL MIX ]
ALL PRE [ALL MIX ]
Switch the send position of the signal sent from the
selected input channel to all MIX buses to either post-
fader or pre-fader.
ALL POST [ALL CH ]
ALL PRE [ALL CH ]
Switch the send position of the signal sent from all
input channels to the selected MIX bus to either post-
fader or pre-fader.
ALL POST [ALL CH x ALL MIX]
ALL PRE [ALL CH x ALL MIX]
Switch the send position of the signal sent from all
input channels to all MIX buses to either post-fader
or pre-fader.
Note
These “all-at-once” operations are ignored by FIXED-type MIX
buses.