User Manual

7 Using the Selected Channel section
60 PM5D/PM5D-RH Owner’s Manual Operating section
Here you can switch the on/off status of the signal sent
from the selected channel to the STEREO bus, and adjust
the pan.
A STEREO [PAN] encoder
The function of this encoder depends on the currently
selected channel, as follows.
B [TO STEREO] key
The function of this key depends on the currently
selected channel, as follows.
Here you can edit compressor parameters for the selected
channel. This section is available only if a channel other
than an FX RTN channel is selected.
A COMP GR meter
This meter indicates the amount of reduction pro-
duced by the compressor of the selected channel.
B COMP [ON] key
Switches the compressor on/off for the selected
channel.
C COMP [ATTACK] indicator
Indicates the attack time of the compressor in msec
units.
D COMP [ATTACK] encoder
Specifies the attack time of the compressor (the time
from when the signal exceeds the threshold level until
compression begins).
E COMP [RELEASE] indicator
Indicates the release time of the compressor in msec
units or sec units (the indicator for the displayed unit
will light).
F COMP [RELEASE] encoder
Specifies the release time of the compressor (the time
from when the signal falls below the threshold level
until compression is removed).
G COMP [RATIO] indicator
Indicates the compression ratio setting.
H COMP [RATIO] encoder
Specifies the compression ratio (the ratio at which the
input signal will be compressed when the signal
exceeds the threshold level).
I COMP [THRESHOLD] encoder
Specifies the threshold level of the compressor (the
level at which the compressor will operate). The input
signal will start being compressed when the signal
exceeds this level; compression will be removed when
the signal falls below this level.
Selected channel Function
Input channel
Adjusts the panning of the signal
sent from that channel to the STE-
REO bus.
ST IN channel
FX RTN channel
MIX channel
STEREO A/B channels
Adjusts the left/right balance of the
signal sent from the STEREO A/B
channels.
MATRIX channel No function.
Selected channel Function
Input channel
Functions as an on/off switch for
the signal sent from that channel
to the STEREO bus.
ST IN channel
FX RTN channel
MIX channel
STEREO A/B channels
No function.
MATRIX channel
STEREO
1
2
COMPRESSOR
9
2
J
8
6
4
3
5
7
1