User Manual

DME-N Network Driver Installation Guide for M7CL/LS9/DSP5D 12
When controlling the device from your computer via Ethernet, the device does not operate
correctly.
• Is the Ethernet cable connected correctly?
Refer to the “Connection of computer and device” section.
• Is the DME-N Network Driver set up appropriately?
Refer to the “Setup” section.
• Did you enter an appropriate IP address of the device?
For details on making settings of the IP Address of the devices, refer to the owner’s manual for each device.
If you are connecting the device to your computer in a one-to-one connection, we recommend that you make the following
initial settings.
Refer to the installation guide for each editor software when connecting to multiple devices with network switch.
• Is the computer network setup appropriately?
Confirm the network setup by following the procedures in the “TCP/IP Settings” section.
If you are connecting the device to your computer in a one-to-one connection, we recommend that you make the following
settings.
Refer to the installation guide for each editor software when connecting to multiple devices with network switch.
• Are the settings of the device and peripheral network devices (including switching hubs) appropriate?
Refer to the relevant owner’s manuals for the device and peripheral network devices (including switching hubs) for details.
• Have you selected an appropriate ports in the Editor and Studio Manager?
Select the device as the input/output port settings of Editor and Studio Manager.
• Are you using the latest DME-N Network Driver?
The latest driver can be downloaded from the Yamaha website http://www.yamahaproaudio.com/
• Are the settings of your security software appropriate?
If using Windows firewall:
For Windows XP
Click [Control Panel]  [Windows Firewall]  [General] tab. Remove the [Don’t allow exceptions] checkbox.
For Windows Vista
Click [Control Panel]  [Windows Firewall]  [Change settings]  [General] tab. Remove the [Block all incoming
connections] checkbox.
For Windows 7 / 8
Click [Control Panel]  [Windows Firewall]. Confirm the communication with the DME-N Network Driver is permitted at
[Inbound Rules] and [Monitoring]  [Firewall].
Troubleshooting (FAQ)
IP address 192.168.0.128 (M7CL/LS9),
192.168.0.129 (DSP5D)
Gateway address 192.168.0.1
Subnet mask 255.255.255.0
IP address 192.168.0.3
Subnet mask 255.255.255.0
Default gateway 192.168.0.1