User Manual

DME-N Network Driver Installation Guide for M7CL/LS9/DSP5D 3
To operate your Yamaha hardware from your computer via Ethernet, you’ll need to install the DME-N Network Driver
software.
DME-N Network Driver is software that transfers MIDI data back and forth between your computer and the
hardware via Ethernet cable.
Connect the computer to device by using an Ethernet cable via a network switch. When you connect the computer
to the device directly, use an Ethernet cable.
NOTE When you connect the computer to the M7CL directly, use a crossover cable.
DME-N Network Driver applies to the system requirements of Editor. Refer to the Editor’s Installation Guide for
details.
The way to access the Control Panel will depend on your operating system.
Windows XP / Vista / 7
Select [Start]  [Control Panel].
Windows 8
1 In the Start screen, click [Desktop].
The desktop will appear.
2 Move the cursor to the upper right or lower right corner of the desktop.
The Charms bar will appear.
3 Select [Settings]  [Control Panel].
DME-N Network Driver
Connection of computer and device
Minimum System Requirements
Accessing the Control Panel
Editor
Driver
Computer
Ethernet cable Ethernet cable
Network switch
or
Crossover cable
Device