User Manual

ManualsBrandsYamaha ManualsDJ EquipmentPM5D

PM5DV2/DSP5D Editor Owner’s Manual

❏ Pan / Fader

A DIRECT (except for FX RTN channels)

Turns the direct output on/off.

B Direct Output Port (except for FX RTN channels)

Choose the port from which this input channel 1–48 or this ST IN channel 1–4 will be

directly output.

C Direct output point (except for FX RTN channels)

Here you can select the direct out point from the following choices: PRE ATT, PRE HPF,

PRE EQ, PRE FADER, and POST ON.

D FOLLOW PAN

Use the following two buttons to specify how the signal sent from the input channel to

the MIX bus will be affected by the TO ST PAN knob (

6).

•VARI button

If this button is on, the PAN knob displayed in the CH to MIX area will be linked

with the TO ST PAN knob if VARI-type MIX buses are paired.

• FIXED button

If this button is on, the signal from after the TO ST PAN (6) knob will be sent to

FIXED-type MIX buses.

E TO ST (To stereo)

This is an on/off switch for the signal sent from the input channel to the STEREO bus.

This is linked with the [TO STEREO] key in the SELECTED CHANNEL section of the

panel.

F TO ST PAN (To stereo pan)

Adjusts the panning of the signal sent from the input channel to the STEREO bus. This

is linked with the encoder of each channel if PAN is selected as the encoder mode, and

with the [PAN] encoder of the SELECTED CHANNEL section. This may be BALANCE

depending on the PAN mode.

G PAN MODE SELECT

Here you can select the PAN mode from the following choices: INDIVIDUAL, GANG

PAN, INV. GANG, and BALANCE.

H LCR

Turns LCR mode on/off for each channel. If this is turned on for a channel, you can use

the TO ST PAN (

6) knob to simultaneously control the level of the signal sent to the

STEREO bus L/R channels and CENTER channel.

I CSR (Center Side Ratio)

This adjusts the level ratio (0–100%) of the CENTER channel relative to the STEREO

bus L/R channels. To change the value, drag upward or downward inside the numerical

box.

J ON

Switches the input channel on/off. This is linked with the INPUT channel strip CH

[ON] keys on the PM5D panel.

K Fader

Adjusts the input level of the input channel. This is linked with the INPUT channel strip faders on the PM5D panel.

The current value is shown in the numerical box immediately below. A level meter is shown beside the fader.

L CUE

This button cue-monitors the signal of the input channel. This is linked with the INPUT channel strip [CUE]

keys on the PM5D panel. If SOLO is active, this will function as SOLO.

NONE No assignment

S1-1, S1-2...S4-15, S4-16 Output channels of an I/O card installed in slots 1–4

2TR D1L, 2TR D1R...2TR D3R

L/R channels of 2TR OUT DIGITAL jacks 1–3

This cannot be selected on the DSP5D