User Manual

PM5DV2/DSP5D Editor Owner’s Manual

❏ Pan / Fader

A TO ST (To stereo)

This is an on/off switch for the signal sent from the MIX channel to the STEREO bus.

The PRE button located below selects PRE (immediately before the MIX [ON] key) or

POST (immediately after the MIX [ON] key) as the point from which the signal is sent

from the MIX channel to the STEREO bus.

B TO ST PAN (To stereo pan)

Sets the panning of the signal sent from the MIX channel to the STEREO bus.

C LCR

Turns LCR mode on/off for each channel. If this is turned on for a channel, you can use

the TO ST PAN (

2) knob to simultaneously control the level of the signal sent to the

STEREO bus L/R channels and CENTER channel.

D CSR (Center Side Ratio)

This adjusts the level ratio (0–100%) of the CENTER channel relative to the STEREO

bus L/R channels. To change the value, drag upward or downward inside the numerical

box.

E BALANCE

This adjusts the left/right output balance of paired channels. This is not shown if pair-

ing is not speciﬁed.

F ON

Switches the MIX channel on/off. This is linked with the MIX [ON] keys in the MIX

section of the PM5D panel.

G Fader

Adjusts the output level of the MIX channel. This is linked with the MIX encoders on

the PM5D panel (if the [MIX MASTER] key is on). The current value is shown in the

numerical box immediately below. A level meter is shown beside the fader.

H CUE

This button cue-monitors the signal of the MIX channel. This is linked with the MIX

[CUE] keys in the MIX section of the PM5D panel. If SOLO is active, this will function

as SOLO.