User Manual

PM5DV2/DSP5D Editor Owner’s Manual

In this window of the editor you can edit and view the DSP5D’s oscillator status.

Choose [Windows] → [Monitor] → [Oscillator] to access this window.

PM5D Editor does not have a corresponding window.

A OSC ON/OFF (oscillator on/off)

This switches the oscillator on/off.

B OSC MODE (oscillator mode)

Here you can select from the following choices of waveform or noise that the oscillator will produce.

SINE WAVE 1CH .......Sine wave x 1 channel

SINE WAVE 2CH .......Sine wave x 2 channels

PINK NOISE..............Pink noise

BURST NOISE ...........Burst noise (intermittently output pink noise)

C PARAMETERS

Specify the following items according to your choice in 2.

• LEVEL

This knob adjusts the output level of the oscillator. The range is –96 dB to 0 dB. The output level is shown by

the level meter located beside.

• FREQ (frequency)

Here you can specify the frequency of the sine wave that is output by the oscillator. Use the knob to specify a

frequency in the range of 20 Hz–20 kHz. (The current setting is shown by the numerical box located above the

knob.) You can select a preset frequency by clicking one of the 10 kHz / 1 kHz / 100 Hz buttons.

If SINE WAVE 2CH is selected, the level and frequency of each channel can be set independently.

Oscillator window

1 2

For SINE WAVE 2CH For PINK NOISE For BURST NOISE

HINT