User Manual

11/34
The SCENE RECALL LINK switch in
the DME CONTROL-SETUP screen
will enable PM5D to send a MIDI
message through the cascade
connection to recall a scene in the
DME, following the Program Change
table assignments.
You need to switch on PROGRAM
CHANGE Tx. (It doesn’t matter about
the MIDI PORT selection, as it will use
the CASCADE IN/OUT ports
automatically.)
PM5D & DME64N CASCADE / Mode 2: Remote Control & One-way Audio: PM5D to DME64N
■ Scene Recall MIDI Link
You need to switch on Program Change Rx. (It doesn’t matter
about the MIDI PORT selection, as it will use the CASCADE
IN/OUT ports automatically.)
PM5D has a default Program Change assignment of 1-to-1, but
DME’s Program Change table will need to be set up by the
user: assign any scene to any number. (Click ‘All Assign’ for a
quick set-up.)