User Manual

28/34
Example of how to configure MY16-C (for peer-to-peer connection):
BUNDLE ASSIGNMENT (using the switches on the card’s panel):
SERIAL ASSIGNMENT (using the switches on the card’s circuit board):
Internal DIP switches of MY16-C:
NOTE:
Use a cross-connected CAT5 cable.
OUT 2 OUT 1 IN 2 IN 1
PM5D slot: 2-2 2-1 1-2 1-1
DME slot: 1-2 1-1 2-2 2-1
RX TX
PM5D slot: 1 2
DME slot: 2 1
1 ON 24-Bit word length
2 OFF 48 kHz
3 ON 1.33ms latency
4 OFF
5 OFF Network Sync: MY16-C cards are word clock master
6 OFF
7 OFF Reserved: no function
8 OFF
PM5D & DME24N with MY16-C/MY16-CII / Remote Control & Bi-directional Audio (Using MY16-C/MY16-CII)
■ MY16-C Setup
BUNDLE ASSIGNMENT
SERIAL ASSIGNMENT
DIP Switch
RX TX