Owner`s manual

122 Chapter 13—Onboard Effects
03D—Owner’s Manual
Applying Effects
1. Press the [EFFECT 1] or [EFFECT 2] button to select an effects processor.
2. Use the [SEL] and [MIXING LAYER] buttons to select a channel.
3. Raise that channel’s fader to the 0 position.
Having pressed the EFFECT 1 or EFFECT 2 button in step 1, the channel faders are
working as effects send faders.
The left and right signals of the stereo input channel are summed into a mono signal
before being sent to the Aux Send buses.
4. Raise the EFFECT RETURN fader to the 0 position.
If you are using Effect 1, EFFECT RETURN 1 is automatically selected. Likewise, if you
are using Effect 2, EFFECT RETURN 2 is automatically selected.
5. Use the [EFFECT 1] or [EFFECT 2] button to locate the Effects Library page
and recall an effects program that uses the type of effect required. See
Recalling Effects Programs on page 127 for more information.
Effects programs are recalled to the currently selected effects processor. To recall an
effects program to Effect 1, use the [EFFECT 1] button to locate the Library page. To
recall an effects program to Effect 2, use the [EFFECT 2] button.
6. Use the [EFFECT 1] button to locate the Eff. Edit page for Effect 1 or the
[EFFECT 2] button to locate the Eff. Edit page for Effect 2.
7. Use the cursor buttons to select the parameters, and the PARAMETER
wheel or mouse to adjust them.
8. Use the Pre/Post page to configure aux sends as either pre-fader or
post-fader sends. See Pre-fader/Post-fader Effects Sends on page 123 for
more information.
9. Use the effects library to store the effects settings for future use. See
Effects Library on page 125 for more information.
10. Set the EQ, pan, dynamics processors, and so on for the effect return
channel. See Effects Returns on page 123 for more information.