User`s guide

Recalling a Dynamics Program 75

ProMix 01 User’s Guide

1. Press [COMP] repeatedly to

select a processor: 1, 2, or 3.

The COMP LCD function

appears. If you didn’t exit

after your last COMP edit, the

COMP EDIT LCD function

appears instead.

2. Select RECALL.

3. Use the PARAMETER wheel

to select a program.

4. Press [ENTER] to recall.

The program is recalled.

Recalling a Dynamics Program

There are 10 preset programs (1–10) and 10 user programs (11–20).

Shown below is the COMP LCD function. Setup parameters appear

in the top part of the display. Programs are listed in the center and

the name of the program last recalled or stored is highlighted. Also

there is an equal symbol (=) between the program’s name and num-

ber, not a period like the other programs. The PARAMETER wheel

is used to scroll through the program list. When another program is

selected, its name ﬂashes. If it is recalled, it stops ﬂashing, appears

highlighted, and the period between its name and number changes

to an equal symbol (=).

Dynamics Processors and Mix Scenes

Dynamics processor settings are stored in mix scenes, so you can

instantly change processors just by recalling a mix scene. If you are

using a controlling computer or MIDI sequencer, you can also record

processor setting adjustments as MIDI Control Change messages.

Your adjustments can then be replayed automatically. See “Control

Change” on page 83 for more details. Note that mix scenes store only

the current program names, numbers, and parameter settings for

COMP1, COMP2, and COMP3. They do not store the entire dynam-

ics processor library of 20 programs.