User`s guide

Chapter 9: MIDI

ProMix 01 User’s Guide

— all Control Changes use the Tx Ch MIDI Channel, and

Control Change #98 (Non-Registered Parameter LSB) is used to spec-

ify banks.

To reset the Control Change assignments to their initial values, select

RESET and press [ENTER]. An “Are your sure” message appears.

Select YES to reset, NO to cancel, then press [ENTER] again.

If several parameters are assigned to the same Control Change in the

same bank, the lowest numbered parameter is controlled when that

Control Change is received. When any one of the parameters is

adjusted, the assigned Control Change is output as normal.