User Manual

Connections and IP addresses of compatible devices
For the latest supported devices and supported firmware versions, see the download page.
As of March 2023
Connector IP Address
*3 - For monitoring Nexo NXAMPmkII s eries amplifiers , us e the NXRM 10 4 or NXAE104 cards only.
*1 - It is recommended to us e a dedicated network interface connected to the Network [PC] terminal of RIVAGE PM series for the bes t s ys tem
performance. Other devices should be connected via different network interfaces.
*2 - In order to reduce communication load on device NETWORK control terminals , it is recommended that devices connected via NETWORK control
terminals use different network interfaces from the Dante network.
IP Address Se tting
Cannot be changed.
Once you have set the IP addresses of the PC and the devices to be monitored, connect them to the network(s) -
ProVisionaire Edge automatically detects the compatible devices and registers them for monitoring.
REMOTE CONTROL SETTINGS
UTILITY -> NETWORK
Set by UNIT ID and DIP switches to 192.168.0.xxx, or by MTX-MRX Editor to
any address.
Set by UNIT ID and DIP switches to 192.168.0.xxx, or by MTX-MRX Editor to
any address.
Set by UNIT ID and DIP switches to 192.168.0.xxx, or by Amp Editor to any
address.
Set by UNIT ID and DIP switches to 192.168.0.xxx, or by Amp Editor to any
address.
SETUP -> NETWORK -> FOR MIXER CONTROL
SETUP -> IP ADDRESS
Settings -> IP Settings -> DME Control Port
Device
NETWORK -> CONTROL
Any
Any
192.168.53.xxx
(fixed)
Any
Any
Any
Any
RIVAGE PM series
(console, DSP) *1
Any
Any
Any
Any
NETWORK
connector
NETWORK
connector
Dante Primary
connector
Expans ion slot
connector
Dante Primary
connector
XMV series *2
XMV-D series
Nexo NXAMPmkII series*3
DZR/DXS-D series
NETWORK [PC]
connector
NETWORK
connector
Dante Primary
connector
NETWORK
connector
Dante Primary
connector
NETWORK
connector
CL/QL series *2
Rio-D2 series
DME7 *2
MRX7-D, MTX5-D
MTX3 *2
PC-D series