User Manual

43
Tool bar
This contains buttons for commands that are frequently used with a
ProVisionaire Control project, such as [Open Project File] or [Save].
In initial mode, the two buttons [New Project] and [Open Project
File] are shown.
Button Command Summary
[New
Project
Wizard]
Creates a new project file. If you were
editing the project file, a confirmation
message appears.
The “New Project Wizard” dialog box
appears even if the “New Project Wiz-
ard” dialog box’s [Don’t show this dia-
log again when creating new project]
check box is selected.
[New
Project]
Creates a new project file. If you were
editing the project file, a confirmation
message appears.
If the “New Project Wizard” dialog
box’s [Don’t show this dialog again
when creating new project] check box
is selected, the “New Project Wizard”
dialog box does not appear; the proj-
ect is created with the “Controllers”
area and “Devices” area blank.
[Open
Project File] /
[Open
Controller
File]
Opens an existing project file or con-
troller file.
If you were editing the project file, a
confirmation message appears.
[Save] Overwrite-saves the project file. The
first time a file is saved, the “Save File”
dialog box opens; assign a name to
the file and save it.
[Run] Runs the selected controller in control
mode. If the controller’s [Type] is ProVi-
sionaire Touch KIOSK, this opens the
“Run Controller File” dialog box. Trans-
fer the controller, and use ProVision-
aire Touch KIOSK on the iPad to verify
that it operates.
[Export] Creates a controller file for the
selected controller. This also transfers
the ProVisionaire Touch KIOSK con-
troller file to the iPad on which ProVi-
sionaire Touch KIOSK is installed.
Button Command Summary