User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
61
boosted or cut. Use this for purposes such as bass boost. [6dB/Oct] and [12dB/Oct]
specify the amount of attenuation per octave.
• H.SHELF (High Shelf)
The volume of the entire high-frequency region above the specified frequency will be
boosted or cut. Use this for purposes such as high boost. [6dB/Oct] and [12dB/Oct]
specify the amount of attenuation per octave.
• HPF(High Pass Filter)
The region below the specified frequency will be cut.
• LPF(Low Pass Filter)
The region above the specified frequency will be cut.
d Q-B/W[OCT] list box / knob
Select the type of frequency bandwidth for each band in the list box, and set the width
with the knob. In [B/W], the setting unit is octaves.
e [Freq] knob
Adjusts the center frequency of each band.
f [Gain] knob
Specifies the gain in each band’s frequency region.
g [FLAT] button
Moves all [Gain] knobs to the 0 position.
h [BYPASS] button
Specifies whether each band is bypassed. If you click a button to make it light, that band
is bypassed.
Control
There are no parameters that can be controlled through the Control layer.