User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
88
c Channel matrix
Shows the send level and delay for each channel. The vertical axis shows the input
channel, and the horizontal axis shows the output channel. A cross-point is displayed
when the cursor is placed over this. It changes to selection mode when clicked. Press the
up/down arrow keys or hold down the left mouse button and move up or down to change
the value. The numeric value can also be entered directly by double clicking. Press the
<Tab> key to move right.
When you double-click a port name display area located above or to the left of the matrix,
a window opens, allowing you to edit the name of the port.
Right-clicking on a cross-point allows the cross-point to be set on or off, the send level to
be set, as well as the ability to turn the horizontal or vertical axis with the cross-point on
or off and setting its send level. The settings of a horizontal/vertical axis can be copy &
pasted to another horizontal/vertical axis, or the display can be changed to a bar graph.
The following choices are provided.
• [One Input to All Outputs]
Opens the One Input to All Outputs window.
• [All Inputs to One Output]
Opens the All Inputs to One Output window.
• [On]
Turns the cross-point ON.
• [Off]
Turns the cross-point OFF.
• [Nominal]
Sets the cross-point's send level to 0 dB.