User Manual

Creating Your Own Original Voices
20
 Filter
 LFO
4. Repeat Step 1 through Step 3 to edit the other Elements.
Using the Element Edit button (page 12, o) on the Voice Editor window, you can also copy the settings from an edited
Element to another.
This completes the Normal Voice procedure for Step 5 on page 13. You should now proceed to Step 6.
Filter EG By dragging the Initial, 1
st
, 2
nd
, 3
rd
, and Release points within the graph, you can set how the
cutoff frequency will change over time between pressing a key and the sound fading away
completely.
Filter Touch Sense By dragging the Cutoff Sense and Resonance Sense points up and down within the graph, you
can set the sensitivity of the filter’s cutoff frequency and the resonance to velocities.
Wave Selects the LFO waveform.
Speed Adjusts the speed (frequency) of LFO variation.
Time By dragging the Delay Time and Fade Time points left and right within the graph, you can set
how the effect of the LFO changes over time.
Delay Time: Adjusts the delay between key-on and the beginning of the LFO effect.
Fade Time: Adjusts the length of the LFO fade-in time, beginning after the Delay Time
(above) and ending when the LFO reaches full amplitude.
A. Mod Depth Sets the depth of modulation applied when the LFO is used for amplitude modulation.
P. Mod Depth Sets the depth of modulation applied when the LFO is used for pitch modulation.
F. Mod Depth Sets the depth of modulation applied when the LFO is used for frequency modulation.
Key On Reset When this is set to on, the LFO phase is reset with each note-on event.
Time
Filter
Initial
Release
3
rd
2
nd
1
st
Velocity
Filter
Cutoff Sense
Resonance Sense
Time
Depth
Delay Time
Fade Time