User Manual

Recording Your Performance
PSR-E473, PSR-EW425 Owner’s Manual
48
3
Specify the track to record and over-
write, and enter Record Ready mode.
 If you want to record only the melody:
While holding down the [REC] button, press the
button for the track you want to record to ([1/
RIGHT] to [5]).
 If you want to record only the Style:
Press the [STYLE] button, and select a Style.
While holding down the [REC] button, press the
[A] button. ACMP is automatically turned on.
 If you want to record only the Groove:
Press the [GROOVE CREATOR] button, and
then select the desired Groove. ACMP is auto-
matically turned on.
While holding down the [REC] button, press the
[A] button.
4
Same as Steps 4 to 6 in “Recording a
New User Song” (page 46).
This lets you clear all tracks of a User Song.
1
Press the [SONG/AUDIO] button. The
SONG icon appears.
If the AUDIO icon appears, press the [SONG/
AUDIO] button again. If “No USB” is displayed
instead of the SONG icon, wait a few seconds for
the SONG icon to appear.
2
Rotate the dial to select the User Song
from 031 to 040 (User 1 to 10) to be
cleared.
3
While holding down the [1/RIGHT] button
press the [A] button.
A confirmation message will appear on the dis-
play.
4
Press the [ENTER] button.
“Sure?” appears on the display. To cancel this
operation, press the [EXIT] button.
5
Press the [ENTER] button again to clear
the Song.
“Writing!” appears briefly on the display, and then
the Song is cleared.
If the internal memory becomes full while recording, an
alert message will appear and recording will stop automat-
ically. In this case, delete unnecessary data by the Clear
functions (below), and then execute the recording again.
User 1
001
PEC
Selected track flashesFlashes
Press and hold
Press and hold
Press and hold
NOTE
Clearing a User Song (Song
Clear)
Press and hold
ClrUser1