manual

PSR-S670 Reference Manual 73
8
Mixing Console
Selecting an Effect Type for each Block
1 Call up the desired page from PANEL, STYLE or SONG by pressing the [MIXER]
button, repeatedly, if necessary.
2 In the EFFECT page, press the [ENTER] button to call up the Effect Type Selection
display.
3 Use the [1 ]/[2 ] buttons to select the Effect Block.
4 Use the [3 ] buttons to select the Part to which you want to apply the effect.
Note that a Part cannot be selected if “REVERB,” “CHORUS,” or “DSP1” (when the “Connection”
parameter is set to “System;” see page 74 for details) is selected. This is because only one of the Effect
Types can be selected to be commonly applied to all available Parts.
5 Use the [4 ]/[5 ] buttons to select the Category, and then use the [6 ]/
[7 ] buttons to select the Effect Type.
Note that the Reverb Block is not divided into any Categories.
If you want to edit detailed Parameters of the selected Effect Type, press the [8 ] (DETAIL) button.
For details, refer to the next section.
6 Save the Effect Settings to a Registration Memory, Song or Style.
For instructions, refer to the Owner’s Manual.
Effect
Block
Effect-applicable
parts
Effect characteristics
REVERB All parts Recreates the warm ambience of playing in a concert hall or jazz
club.
CHORUS All parts Produces a richly textured sound as if several parts are being played
simultaneously. In addition, other type effects (such as reverb, delay,
etc.) can also be selected in this effect block.
DSP1 Style part,
Song channel 1–16
In addition to Reverb and Chorus, a wide variety of Effect Types are
provided, such as Distortion and Wah.
DSP2,
DSP3,
DSP4
RIGHT 1 (R1),
RIGHT 2 (R2),
LEFT,
Song channel 1–16
In addition to Reverb and Chorus, a wide variety of Effect Types are
provided, such as Distortion and Wah. For each of DSP2–4, you can
select one of the Parts or Channels listed at left. When you select
“R2” for DSP2, for example, the DSP2 Effect is applied only to the
Right 2 part. Note that if you select a Song or Style which needs the
DSP2–4 Blocks, the Part assignment of these three Blocks will be
changed automatically with last priority according to the data.