manual

74 PSR-S670 Reference Manual
8
Mixing Console
Editing and Saving Your Original Effect Type
1 Once you’ve selected an Effect Block and Effect Type in the previous section, press
the [8 ] (DETAIL) button to call up the display for editing the effect parameters.
2 Use the [2 ]–[4 ] buttons to select a parameter then use the [5 ]/[6 ]
buttons to edit the value.
When Reverb, Chorus, or DSP1 is selected as the Effect Block, you can adjust the Return Level via the
[7 ] (EFFECT RETURN LEVEL) button.
3 If DSP2, 3 or 4 is selected as the Effect Block, edit the Variation parameter if desired.
Press the [7 ] (VARI. DETAIL) button to call up the Variation parameter, select a parameter via the
[2 ]–[4 ] buttons, and then use the [5 ]/[6 ] buttons to edit the value. This parameter is
effective only when the [DSP VARI.] button lamp lights on the panel. To close this display, press the
[EXIT] button.
4 Press the [8 ] (SAVE) button to call up the display for the Save operation.
5 Use the [3 ]–[5 ] buttons to select the destination for saving the settings as a
User Effect.
If necessary, change the User Effect name. Press the [6 ] (RENAME) button to call up the Character
Entry window, enter the name, and then press the [8 ] (OK) button.
6 Press the [8 ] (OK) button to carry out the Save operation.
7 Press the [EXIT] button to return to the previous display.
The saved User Effect can be selected from the “User” category of the corresponding Effect Block
(page 73).