Owner's Manual

PSR-S670 Owner’s Manual 15

Setting Up

To prevent unnecessary power consumption, this instrument features an Auto Power

Off function that automatically turns the power off if the instrument is not operated

for a specified period of time. The amount of time that elapses before the power is

automatically turned off is approximately 30 minutes by default; however, you can

change the setting.

1 Call up the operation display.

[FUNCTION]  TAB [ E] MENU 1  Cursor buttons [][][E][F]

UTILITY  [ENTER]  TAB [ E] CONFIG 1

2 Use the Cursor button [] to select “4. AUTO POWER OFF.”

3 Use the [4 ]/[5 ] buttons to set the value.

If you do not want to turn the power off automatically (disable the Auto Power

Off), select DISABLED.

Press the [EXIT] button several times to return to the Main display.

NOTICE

While recording or editing, or while a message is displayed, the power cannot be turned off even if you press the [ ] (Standby/On)

switch. If you want to turn off the power, press the [ ] (Standby/On) switch after recording, editing, or after the message has disap-

peared. If you need to force-quit the instrument, hold down the [ ] (Standby/On) switch for longer than three seconds. Note that the

force-quit operation might cause data loss and damage to the instrument.

Setting the Auto Power Off function

NOTICE

The data which is not saved to

the USER or USB drive will be

lost if the power automatically

turns off. Make sure to save your

data before the power turns off

(page 26).

Disabling Auto Power Off (simple method)

Turn the power on while holding down the lowest key on the keyboard. A message appears briefly, then the

instrument starts up with the Auto Power Off function disabled.