User Manual

PSR-SX600 Reference Manual 17
1
Voices
 Effect Page
1 Reverb Depth/Chorus Depth/DSP Depth/Panel Sustain
2 DSP Type
3 EQ
 Harmony/Arp Page
Same as the display called up via [MENU] → TAB [E] Menu1 → Cursor buttons [][][E][F]
Harmony/Arpeggio → [ENTER], with the exception of the following points:
• The parameters set via the [7 ] (Detail) buttons are shown on the top of the display.
•The [8] (Compare) and [8 ] (Save) buttons are available (see steps 4–5 on page 13).
[1 ]/
[2 ]
Reverb Depth Adjusts the reverb depth.
[3 ]/
[4 ]
Chorus Depth Adjusts the chorus depth.
[5 ] DSP On/Off Determines whether the DSP effect is on or off.
This setting can also be made from the VOICE EFFECT [DSP] button on the
panel.
[6 ] DSP Depth Adjusts the DSP depth.
If you want to re-select the DSP type, you can do so in the “2 DSP Type” menu
explained below.
[7 ] Panel Sustain Determines the sustain level applied to the edited Voice when the sustain effect is
on. To turn on/off the sustain effect, press the [SUSTAIN] button, or set it from
the display below.
[MENU] → TAB [E] Menu1 → Cursor buttons [][][E][F] Voice Setting →
[ENTER] → TAB [E] Voice Control
[2 ]/
[3 ]
Category Selects the DSP effect category and type. Select a type after selecting a category.
[4 ]/
[5 ]
Type
[6 ]/ Detail Calls up a detailed setting display. Use the [2 ]–[4 ] buttons to select the
desired parameter, and then use the [5 ]–[6 ] buttons to adjust the value
of the desired parameter. To close the detailed setting display, press the [EXIT]
button.
[1 ]/
[2 ]
Low Frequency Determines the desired frequency of the low frequency band to be controlled, over
a range of 32Hz–2.0kHz.
[3 ] Low Gain Boosts or attenuates the low EQ band set above over a range of -12dB–12dB.
[4 ]/
[5 ]
High Frequency Determines the desired frequency of the high frequency band to be controlled,
over a range of 500Hz–16kHz.
[6 ]
High Gain Boosts or atten
uates the high EQ band set above over a range of -12dB–12dB.