User Manual

Table Of Contents
PSR-SX600 Owner’s Manual 37
Voices – Playing the keyboard –
1
The Voices can be played via three keyboard parts: LEFT, RIGHT 1 and 2. You can combine these parts by using
the PART ON/OFF buttons to create luscious instrument textures and convenient performance combinations.
To play one single Voice on the entire keyboard:
Turn on the RIGHT 1 or 2 part.
To play two different Voices in layer on the entire keyboard (Layer):
Turn on the RIGHT 1 and 2 parts.
To play different Voices in the right- and left-hand sections of the key-
board (Split):
Turn on the LEFT and RIGHT (1 and/or 2) parts. The F#2 and lower keys are used
for the LEFT part while the upper keys (excluding F#2) are used for the RIGHT 1
and 2 parts. The key which divides the keyboard into the left-hand and right-hand
sections is referred to as the “Split Point.
1 Turn on the PART SELECT button corresponding to the part you
want to use.
2 Select the Voice for the selected part.
For instructions on selecting Voices, refer to page 34.
3 If necessary, repeat steps 1 and 2 on page 34 to select the Voice
for the other part.
4 Turn on the PART ON/OFF button corresponding to the part(s)
you want to use.
5 Play the keyboard.
Selecting Voices for the Parts
RIGHT 2 part
RIGHT 1 part
LEFT part
For selecting the keyboard part to change the Voice
For turning on/off the keyboard parts
Right-hand (UPPER) sectionLeft-hand (LOWER) section
Split Point (F#2 by default)
NOTE
The Split Point can be changed
(page 57).
4
NOTE
You can save the Voice selection and
on/off setting for each part to Registra-
tion Memory (page 85).
NOTE
The Voice name for each part can be
confirmed on the Main display
(page 18).