User Manual

24 PSR-SX900/SX700 Reference Manual
Assembly—Assigning the Source Pattern to Each Channel
The explanations here apply to step 4 of the Basic Procedure on page 19. The “Assembly” display shows each channel
data of the current Section, and where it has been copied from (Style, Section, and channel). For each channel, touch
the Style name, Section name, or Channel name as necessary to select the desired item.
Channel Edit
The explanations here apply to step 5 of the Basic Procedure on page 19. The “Channel Edit” display lets you edit
already recorded channel data. Select the Target channel and then edit the desired parameters.
After editing the desired parameter, touch [Execute] to actually enter the edits for each setup window. When execution
is completed, this button changes to [Undo], letting you restore the original data if you are not satisfied with the
results. The Undo function only has one level; only the previous operation can be undone.
• (PSR-SX900) An Audio part cannot be copied from another Style. If you want to use a specific Audio part, make sure to select the corresponding Audio Style before call-
ing up the Style Creator display.
• (PSR-SX900) If you select an Audio Style as starting data, the Audio part cannot be replaced with different data.
The edited Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation (step 7
on page 19).
(PSR-SX900) If you select an Audio Style as starting data, the Audio part will be used as is. The Audio part cannot be deleted, edited or created from scratch.
Channels with data are displayed as “On” (in green). Turning
on/off here, you can select whether each channel is played or
not during audition playback.
NOTE
NOTICE
NOTE