Operation Manual

Display unit

The display unit offers the following operations and infor-

mation displays.

2 Battery

Check if the rated battery (CR2032) is installed in the rear

of the display.

If a battery is not installed, or if there is not sufficient bat-

tery power remaining, install a new battery.

To adjust the time and set the units for distance and

speed, see “Clock and km/mile settings”.

TIP

• Make sure that the waterproof seal is installed correct-

ly.

• Please use a new type CR2032 button cell battery (sold

separately).

2 Mounting and removing the display

To mount the display, press the lever on the holder while

sliding the display towards the rear of the bicycle into the

holder. To remove the display, press the lever while sliding

the display towards the front of the bicycle out of the holder.

TIP

• Adjust the display angle by loosening the display angle

adjust bolt. The angle depends on each rider.

• Make sure the display is turned off before mounting or

removing it.

INSTRUMENT AND CONTROL FUNCTIONS

Cover

Waterproof

seal

Battery

Lever

Display

Holder

Display angle

adjust bolt