Operation Manual

BATTERY PACK AND CHARGING PROCEDURE

3. See “Reading the charging status”, and check that the

battery charger is charging the battery pack.

4. The battery capacity indicator lamps will light up one by

one until all four are on. Then, when charging is com-

plete, all of the lamps will go off.

5. Confirm that charging is complete, and then disconnect

the charging plug from the battery pack.

How to disconnect the plug (see the left figure)

Grasp the lock-release ring.

Pull it out straight.

6. Place the cap of charging inlet on the battery pack’s

charging connector.

WARNING

Never handle the power plug, charging plug or touch

the charger contacts with wet hands. This could result

in electric shock.

TIP

• Charging will start automatically.

• If the display unit is turned on while the battery pack is

charging, all normal displays will be shown, including

the battery capacity indicator, but the assist system will

not function.

• When the battery pack is connected to the battery

charger, battery charger lamp will flash at approximate-

ly 0.2 second intervals to indicate that charging is pre-

paring to charge the battery pack. Leave it as it is and

charging will start normally.

[CHARGING THE BATTERY PACK REMOVED FROM

THE BICYCLE]

1. Turn the display unit off.

2. Insert the key into the battery lock, and turn it to re-

lease the battery lock.

3. Remove the battery pack.

WARNING

Use both hands when removing the battery pack, be-

ing careful not to drop it. Dropping the battery pack

on your foot could result in injury.

4. Connect the power plug of the battery charger to a

household power outlet.

5. Remove the cap from the charging connector on the

battery pack, and connect it to the charging plug on the

battery charger.

Lock-release ring