Operation Manual

Display unit

The display unit offers the following operations and infor-

mation displays.

2 Installing the battery

The display needs to be removed and installed for chang-

ing the battery.

• Remove the two bolts on back side of the clamp, and

then remove the display.

• When installing the display, tighten the two display

bolts from the back side of the clamp.

WARNING

Tighten the display bolts to 1.5–2.5 N·m. During rid-

ing, vibration could cause the bolts to come loose

with the risk that the display may fall off.

TIP

• The clamp and display might be installed on the left

side of the stem.

• For models without this clamp, the above note does not

apply.

2 Battery

Check if the rated battery (CR2032) is installed in the rear

of the display.

If a battery is not installed, or if there is not sufficient bat-

tery power remaining, install a new battery.

To adjust the time and set the units for distance and

speed, see “Stopwatch and settings”.

TIP

• Make sure that the waterproof seal is installed correct-

ly.

• Use a new type CR2032 button cell battery (sold sepa-

rately).

INSTRUMENT AND CONTROL FUNCTIONS

Clamp

Display bolt

Cover

Waterproof seal

Battery