Operation Manual

76 - English English - 77

BATTERY PACK AND CHARGING PROCEDURE

6. See “Reading the charging status”, and check that the

battery charger is charging the battery pack.

7. The battery capacity display lamps will light up one by

one until all four are on. Then, when charging is com-

plete, all of the lamps will go off.

8. Confirm that charging is complete, and then discon-

nect the charging plug from the battery pack.

How to disconnect the plug (see the left figure)

Grasp the lock-release ring.

Pull it out straight.

9. Place the cap on the battery pack’s charging connec-

tor.

10.

Mount the battery pack on the bicycle.

TIP

Mounting method of the battery pack

• Insert the battery in the direction of the arrow so that

the battery bottom is aligned to the top of the case.

• Insert the upper part of the battery in the direction of

the arrow so that the battery handle is aligned to the

top of the key lock.

• Press the upper part of the battery toward the frame

until it clicks into place to secure it.

Lock-release ring

Battery bottom

Top of the case

Key lock

Battery handle

BATTERY PACK AND CHARGING PROCEDURE

11.

Make sure that it is securely attached by pulling the

battery after installation.

Make sure there is no foreign matter on the battery

pack contacts before inserting the battery pack.