Operation Manual

XVI - English English - XVII

Structural changes on your S-Pedelec

Since the S-Pedelec is a motor vehicle there are several restrictions concerning structural changes. Table 1 indicates which compo-

nents can be replaced under which conditions.

Table 1: S-Pedelec components and conditions for replacement

Following components on our S-Pedelec can be replaced ...

a) only by original compo-

nents

b) without approval

c) only with offiial approval of

Winora-Staiger GmbH

frame grips fork

drive unit shift lever handlebar, brakes

battery

saddle stem

seat post clamping ring gear shift

chain chainwheel

headset cranks

tube reflectors

tyres (size as in CoC document and others approved by

Winora; have to be type approved)

front / rear light (must have

same illuminance and must be

mounted on the same position)

bell mirror

carrier (max. +15% of original dimensions, position of licence

plate holder must remain the same)

Note: max. carrier load is 15kg

seat post

stand

mud guard (must correspond with the original dimensions

+/- 15%)

rims/hubs/wheels

licence plater holder

Approval of alternative components by Winora-Staiger GmbH

If it is necessary to replace original components due to damage or wear we recommend to use orinigal components. Please contact

your specialist dealer. Winora-Staiger GmbH provides its specialist dealers with a list of orinigal specifications. When replacing

components from table 1a) it is required to only use original components.

Furthermore there is a possibility to use alternative components for parts of table 1b) and 1c). You are relatively free when choosing

parts from column b) of table 1, you have to use components approved by Winora-Staiger GmbH when replacing parts from column

c) of table 1.

Please contact your Haibike / Winora specialist dealer about this matter.

Winora-Staiger GmbH provides its specialist dealers a regularily updated list with approved components.

In case of infringement according to column a) or c) the vehicle loses its type approval and must not be used

anymore.

it is required that the parts meet at least bicycle standard ISO4210 and a professional mounting.