Owner`s manual

Control functions
16
play. Note the error code, and then have a
Yamaha dealer inspect the snowmobile as
soon as possible. NOTICE: Do not continue
to operate the engine longer than neces-
sary if there is an error code to avoid pos-
sible engine damage.
[ECS00820]
ESU10544
Drive select switch
The drive select switch is used to shift the
snowmobile into drive or reverse. After com-
ing to a complete stop, press the drive select
switch.
The drive “D” indicator light comes on when
the transmission is in drive (forward).
The reverse “R” indicator light comes on when
the transmission is in reverse.
NOTICE
ECS00052
Do not use the drive select switch while
the snowmobile is moving. Otherwise, the
drive train could be damaged.
ESU10531
Engine stop switch “”
The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 35 for engine starting
procedures.)
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
ESU10661
Headlight beam switch
“LIGHTS”
Push the headlight beam switch to change the
headlight to high beam “HI” or to low beam
“LO”.
1. Warning light “”
2. Self-diagnosis warning indicator “”
3. Error code display
1. Drive select switch
2. Drive “D” indicator light
3. Reverse “R” indicator light
3
2
1. Engine stop switch “”
U8GK13E0.book Page 16 Wednesday, March 11, 2009 10:54 AM