Owner`s manual

Control functions
17
ESU10674
Grip/thumb warmer adjustment
switch
The grip/thumb warmer adjustment switch
controls the electrically heated handlebar
grips and throttle lever.
To raise the temperature
To raise the grip warmer temperature, press
the “” side of the switch. To raise the thumb
warmer temperature, press the “” side of
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
See “Fuel meter and grip/thumb warmer level
indicator” on page 13 for detailed information.
ESU10691
Auxiliary DC jack (PZ50VT)
The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
3. After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
NOTICE
ECS00120
● Do not use accessories requiring more
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 74 for the specified amperage.)
● Do not use an automotive cigarette light-
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
1. Headlight beam switch “LIGHTS”
2. High beam “HI”
3. Low beam “LO”
1. Grip/thumb warmer adjustment switch
1. Auxiliary DC jack cap
2. Auxiliary DC jack
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
U8GK13E0.book Page 17 Wednesday, March 11, 2009 10:54 AM