Owner`s manual

Periodic maintenance and adjustment
49
2. Fit the holders on the front cover over the
projections on the air filter case cover,
slide the front cover downward, and then
hook the latch onto the holder on the front
of the snowmobile.
Shroud and air filter case cover
(PZ50VT)
To open the shroud and remove the air filter
case cover
1. Unhook the shroud latches, and then
slowly raise the shroud forward until it
stops.
2. Loosen the fasteners, lift up the air filter
case cover slightly, and then unhook the
cover from the air filter case to remove it.
To close the shroud and install the air filter
case cover
1. Insert the projections on the end of the air
filter case cover into the slots in the air fil-
ter case, place it in the original position,
and then tighten the fasteners.
1. Projection on the end of the air filter case
cover
2. Slot in the air filter case
1. Holder on the front cover
2. Projection on the air filter case cover
1. Shroud latch
2. Shroud
1. Air filter case cover
2. Fastener
U8GK13E0.book Page 49 Wednesday, March 11, 2009 10:54 AM