Owner`s manual

Periodic maintenance and adjustment
63
9. Install the V-belt between the secondary
fixed sheave and the secondary sliding
sheave.
10. Install the drive guard.
11. Install the left side cover (PZ50RT /
PZ50GT / PZ50MT), or install the left side
cover and the left upper cover, and then
close the shroud (PZ50VT).
ESU12125
Drive chain housing
To check the drive chain housing oil level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the right side cover. (See page
48 for removal procedures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
4. Remove the dipstick and check that the
oil level is within the range shown at the
bottom of the dipstick. If the oil does not
reach the bottom of the dipstick, add suf-
ficient oil of the recommended type to
raise it to the correct level. NOTICE:
Make sure that no foreign material en-
ters the drive chain housing.
[ECS00531]
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Dipstick
1. Oil level range
Recommended drive chain oil:
SAE 75W or 80W API GL-3 Gear oil
1
U8GK13E0.book Page 63 Wednesday, March 11, 2009 10:54 AM